Document Type : Research Paper
Authors
1
Department of Materials Engineering, Faculty of Mechanical Engineering, University of Tabriz, Tabriz, Iran.
2
Department of Applied Chemistry, Faculty of Chemistry, University of Tabriz, Tabriz, Iran.
3
Department of Physical Chemistry, Faculty of Chemistry, University of Tabriz, Tabriz, Iran.
4
Department of Civil Engineering, University of Tabriz, Tabriz, Iran
10.22059/jufgnsm.2024.02.09
Abstract
To preserve environmental and human health, remediation of the produced wastewater from various industries such as textile and metalworking is of prime significance. The present investigation strives to draw a meaningful comparison between the metalworking fluid (MWF) wastewater chemical oxygen demand (COD) removal ability of three different methods, including coagulation-flocculation, Fenton oxidation, and heterogeneous nano-zeolite catalyzing Fenton-like oxidation processes. The results illustrated that the highest COD removal efficiency achieves through the application of a heterogeneous Fenton-like oxidation process. Also, the influence of nanocatalyst dosage and solution pH on COD removal efficiency of the heterogeneous Fenton-like process is addressed. The concentration of the used catalyst in this method plays a crucial role in its removal ability, wherein COD removal efficiency increases with an increase in the catalyst amount. Besides, the COD removal efficiency of this process is not affected by the pH value of the treated solution. Moreover, the sludge production rate as well as affecting parameters of each method is evaluated. The heterogeneous Fenton-like process provides the lowest sludge production rate, while the maximum sludge production rate is encountered with the coagulation-flocculation route. Therefore, the heterogeneous Fenton-like process overcomes the common challenges facing the successful industrial use of the conventional Fenton process.
Keywords
)