Effects of structure design on electrostatic pull-in voltage of perforated nanoswitch with intermolecular surface forces

Document Type : Research Paper

Authors

1 Institute of Electronics, University of Blida 1, BP. 270 09000, Algeria

2 High School of Hydraulics, Algeria

Abstract

In this paper, we model and investigate the electrostatic pull-in instability of a perforated cantilever nanoswitch subjected to van der Waals and Casimir forces. The nanocantilever is a beam structure perforated with a periodic square holes network, which has been considered as an electrode material for this new structure. Closed-form solutions for the critical pull-in parameters are derived from the standard deformation beam equation, in which an equivalent bending stiffness is considered due to presence of square holes network. The electrostatic and dispersion forces are included by modifying the standard deformation beam equation, while the small scale effect is introduced by using the Eringen’s nonlocal elasticity theory. Pull-in parameters analysis of the perforated nanoswitch indicated that both pull-in voltage and pull-in deflection are affected by the gap ratio as well as the hole size ratio and the number of holes along the section of perforated nanocantilever beam. Therefore, these results are compared with literature results where new remarks are deduced and presented with detailed discussion for a proper design and investigation of M/NEMS nanoswitches.

Keywords

References

  1. Kim P, Lieber CM. Nanotube Nanotweezers. Science. 1999;286(5447):2148-50.
  2. Ponbunyanon P, Limkatanyu S, Kaewjuea W, Prachasaree W, Chub-Uppakarn T. A Novel Beam-Elastic Substrate Model with Inclusion of Nonlocal Elasticity and Surface Energy Effects. Arabian Journal for Science and Engineering. 2016;41(10):4099-113.
  3. Wen-Hui L, Ya-Pu Z. Dynamic Behaviour of Nanoscale Electrostatic Actuators. Chinese Physics Letters. 2003;20(11):2070-3.
  4. Lin WH, Zhao YP. Casimir effect on the pull-in parameters of nanometer switches. Microsystem Technologies. 2005;11(2-3):80-5.
  5. Lin W, Zhao Y. Nonlinear behavior for nanoscale electrostatic actuators with Casimir force. Chaos, Solitons & Fractals. 2005;23(5):1777-85.
  6. Vaghari M, Khayati GR, Jenabali Jahromi SA. Studying on the fatigue behavior of Al-Al2O3 metal matrix nano composites processed through powder metallurgy. Journal of Ultrafine Grained and Nanostructured Materials. 2019 Dec 31;52(2):210-7.
  7. Ramezani A, Alasty A, Akbari J. Closed-form solutions of the pull-in instability in nano-cantilevers under electrostatic and intermolecular surface forces. International Journal of Solids and Structures. 2007;44(14-15):4925-41.
  8. Ramezani A, Alasty A, Akbari J. Influence of van der Waals force on the pull-in parameters of cantilever type nanoscale electrostatic actuators. Microsystem Technologies. 2006;12(12):1153-61.
  9. Rueckes T, Kim K, Joselevich E, Tseng GY, Cheung C-L, Lieber CM. Carbon Nanotube-Based Nonvolatile Random Access Memory for Molecular Computing. Science. 2000;289(5476):94-7.
  10. Sahmani S, Bahrami M. Nonlocal plate model for dynamic pull-in instability analysis of circular higher-order shear deformable nanoplates including surface stress effect. Journal of Mechanical Science and Technology. 2015;29(3):1151-61.
  11. J. Ntayeesh T, Rasheed Ismail M, G. Saihood R. Buckling analysis of reinforced composite plates with a multiwall carbon nanotube (MWCNT). Periodicals of Engineering and Natural Sciences (PEN). 2019;7(3):1275.
  12. Serry FM, Walliser D, Maclay GJ. The anharmonic Casimir oscillator (ACO)-the Casimir effect in a model microelectromechanical system. Journal of Microelectromechanical Systems. 1995;4(4):193-205.
  13. Osterberg PM, Senturia SD. M-TEST: A test chip for MEMS material property measurement using electrostatically actuated test structures. Journal of Microelectromechanical Systems. 1997;6(2):107-18.
  14. Bochobza-Degani O, Nemirovsky Y. Modeling the pull-in parameters of electrostatic actuators with a novel lumped two degrees of freedom pull-in model. Sensors and Actuators A: Physical. 2002;97-98:569-78.
  15. Ding J-N, Wen S-Z, Meng Y-G. Theoretical study of the sticking of a membrane strip in MEMS under the Casimir effect. Journal of Micromechanics and Microengineering. 2001;11(3):202-8.
  16. J. Israelachvili, (1991). Intermolecular and surface forces, 2nd edn. Academic. ISBN 0-12-375181-0 (Chapter 11).
  17. Lamoreaux SK. The Casimir force: background, experiments, and applications. Reports on Progress in Physics. 2004;68(1):201-36.
  18. Lu P, Lee HP, Lu C, Zhang PQ. Application of nonlocal beam models for carbon nanotubes. International Journal of Solids and Structures. 2007;44(16):5289-300.
  19. Yang J, Jia XL, Kitipornchai S. Pull-in instability of nano-switches using nonlocal elasticity theory. Journal of Physics D: Applied Physics. 2008;41(3):035103.
  20. Mousavi T, Bornassi S, Haddadpour H. The effect of small scale on the pull-in instability of nano-switches using DQM. International Journal of Solids and Structures. 2013;50(9):1193-202.
  21. Zeighampour H, Beni YT, Karimipour I. Torsional Vibration and Static Analysis of the Cylindrical Shell Based on Strain Gradient Theory. Arabian Journal for Science and Engineering. 2016;41(5):1713-22.
  22. A. C. Eringen, Int. J. Eng. Sci. 30 (10) (1992) 1551-1565.
  23. Kerid R, Bourouina H, Yahiaoui R, Bounekhla M, Aissat A. Magnetic field effect on nonlocal resonance frequencies of structure-based filter with periodic square holes network. Physica E: Low-dimensional Systems and Nanostructures. 2019;105:83-9.
  24. S. P. Timoshenko, J. M. Gere, 1961 Theory of Elastic Stability (New York McGraw Hill)
  25. Khan MU, Hassan G, Bae J. Non-volatile resistive switching based on zirconium dioxide: poly (4-vinylphenol) nano-composite. Applied Physics A. 2019;125(6).
  26. Ansari R, Gholami R, Faghih Shojaei M, Mohammadi V, Darabi MA. Surface Stress Effect on the Pull-In Instability of Hydrostatically and Electrostatically Actuated Rectangular Nanoplates With Various Edge Supports. Journal of Engineering Materials and Technology. 2012;134(4).
  27. Ghorbanpour Arani A, Ghaffari M, Jalilvand A, Kolahchi R. Nonlinear nonlocal pull-in instability of boron nitride nanoswitches. Acta Mechanica. 2013;224(12):3005-19.
  28. Wang KF, Wang BL, Zeng S. Small scale effect on the pull-in instability and vibration of graphene sheets. Microsystem Technologies. 2016;23(6):2033-41.
  29. Zeraati M, Khayati GR. Optimization of micro hardness of nanostructure Cu-Cr-Zr alloys prepared by the mechanical alloying using artificial neural networks and genetic algorithm. Journal of Ultrafine Grained and Nanostructured Materials. 2018 Dec 1;51(2):183-92.
  30. Soroush R, Koochi A, Kazemi AS, Noghrehabadi A, Haddadpour H, Abadyan M. Investigating the effect of Casimir and van der Waals attractions on the electrostatic pull-in instability of nano-actuators. Physica Scripta. 2010;82(4):045801.
  31. Taghavi N, Nahvi H. Pull-in instability of cantilever and fixed–fixed nano-switches. European Journal of Mechanics - A/Solids. 2013;41:123-33.
  32. Keivani M, Mardaneh M, Koochi A, Rezaei M, Abadyan M. On the dynamic instability of nanowire-fabricated electromechanical actuators in the Casimir regime: Coupled effects of surface energy and size dependency. Physica E: Low-dimensional Systems and Nanostructures. 2016;76:60-9.
  33. Tombler TW, Zhou C, Alexseyev L, Kong J, Dai H, Liu L, et al. Reversible electromechanical characteristics of carbon nanotubes underlocal-probe manipulation. Nature. 2000;405(6788):769-72.
  34. Bourouina H, Yahiaoui R, Kerid R, Ghoumid K, Lajoie I, Picaud F, et al. The influence of hole networks on the adsorption-induced frequency shift of a perforated nanobeam using non-local elasticity theory. Journal of Physics and Chemistry of Solids. 2020;136:109201.
  35. Chan J, Eichenfield M, Camacho R, Painter O. Optical and mechanical design of a “zipper” photonic crystal optomechanical cavity. Optics Express. 2009;17(5):3802.
  36. Ding J-N, Wen S-Z, Meng Y-G. Theoretical study of the sticking of a membrane strip in MEMS under the Casimir effect-. Journal of Micromechanics and Microengineering. 2001;11(3):202-8.
  37. Frenzel T, Findeisen C, Kadic M, Gumbsch P, Wegener M. Tailored Buckling Microlattices as Reusable Light-Weight Shock Absorbers. Advanced Materials. 2016;28(28):5865-70.
  38. Nawaz H, Masood MU, Saleem MM, Iqbal J, Zubair M. Surface roughness effects on electromechanical performance of RF-MEMS capacitive switches. Microelectronics Reliability. 2020;104:113544.
  39. Lee W, Han H, Lotnyk A, Schubert MA, Senz S, Alexe M, et al. Individually addressable epitaxial ferroelectric nanocapacitor arrays with near Tb inch−2 density. Nature Nanotechnology. 2008;3(7):402-7.
  40. J, W. N. Sharpe, R. Vaidyanathan, B. Yuan, G. Bao, R. L. Edwards, J. Vacu. Sci. Techno. B 15 (5) (1997) 1599-1603.
  41. Rabinovich VL, Gupta RK, Senturia SD. The effect of release-etch holes on the electromechanical behaviour of MEMS structures. Proceedings of International Solid State Sensors and Actuators Conference (Transducers ''97): IEEE.
  42. Luschi L, Pieri F. An analytical model for the determination of resonance frequencies of perforated beams. Journal of Micromechanics and Microengineering. 2014;24(5):055004.
  43. Luschi L, Pieri F. An analytical model for the resonance frequency of square perforated Lamé-mode resonators. Sensors and Actuators B: Chemical. 2016;222:1233-9.
  44. Ouakad HM. Numerical model for the calculation of the electrostatic force in non-parallel electrodes for MEMS applications. Journal of Electrostatics. 2015;76:254-61.
  45. Keivani M, Koochi A, Sedighi HM, Abadian A, Abadyan M. A Nonlinear Model for Incorporating the Coupled Effects of Surface Energy and Microstructure on the Electromechanical Stability of NEMS. Arabian Journal for Science and Engineering. 2016;41(11):4397-410.
  46. Rahmani O, Jandaghian AA. Buckling analysis of functionally graded nanobeams based on a nonlocal third-order shear deformation theory. Applied Physics A. 2015;119(3):1019-32.
  47. Song Y-H, Han C-H, Kim M-W, Lee JO, Yoon J-B. An Electrostatically Actuated Stacked-Electrode MEMS Relay With a Levering and Torsional Spring for Power Applications. Journal of Microelectromechanical Systems. 2012;21(5):1209-17.
  48. Li H, Ruan Y, You Z, Song Z. Design and Fabrication of a Novel MEMS Relay with Low Actuation Voltage. Micromachines (Basel). 2020;11(2):171.
  49. Wong JE. Analysis, design, fabrication, and testing of a MEMS switch for power applications(Doctoral dissertation, Massachusetts Institute of Technology).
  50. Bourouina H, Yahiaoui R, Kerid R, Amine Benamar ME, Brioua F. Mathematical model for the adsorption-induced nonlocal frequency shift in adatoms-nanobeam system. Physica B: Condensed Matter. 2017;520:128-38.
  51. Ansari F, Sheibani S, Caudillo-Flores U, Fernández-García M. Effect of calcination process on the gas phase photodegradation by CuO-Cu2O/TiO2 nanocomposite photocatalyst. Journal of Ultrafine Grained and Nanostructured Materials. 2020 Jun 1;53(1):23-30.
  52. Yang Y, Lim CW. Non-classical stiffness strengthening size effects for free vibration of a nonlocal nanostructure. International Journal of Mechanical Sciences. 2012;54(1):57-68.

 

Journal of Ultrafine Grained and Nanostructured Materials
Volume 54, Issue 2
December 2021
Pages 219-227

Files

History

  • Receive Date: 21 May 2021
  • Revise Date: 04 October 2021
  • Accept Date: 11 October 2021

Share

How to cite

Statistics