Dip coating of silica layer on melt-spun Finemet ribbons: surface morphology and electrical resistivity changes

Document Type : Research Paper

Authors

1 Department of Engineering, Islamshahr Branch, Islamic Azad University, Islamshahr, Iran.

2 Department of Materials Science and Engineering, Sharif University of Technology, Azadi Ave, Tehran, Iran.

Abstract

In this study, melt-spun Finemet ribbons were coated by a thin layer of SiO2 using dip coating method. Amorphous ribbon prepared by melt spinning method and dip coating were done by using a solution of tetraethylen orthosilicate as a SiO2 precursor, ethanol as solvent and distilled water for hydrolysis. Different thicknesses of SiO2 layer, namely 304, 349, 451, 526 and 970 nm were obtained proportional to the number of dipping. Surface morphology and chemical composition of the coatings were analyzed by using Scanning Electron Microscope equipped with an energy dispersive spectroscope. The results clearly verified the presence of Si and O elements and confirmed the presence of silica layer on the surface of all coated ribbons. Microstructure and surface morphology of samples showed a smooth and brittle layer. Electrical resistivity of the samples was measured with a standard four-point probe device. The results confirmed an intense in increase of resistivity. Average value of electrical resistivity for coated samples was around 104 Ω-m compared to 10-6 Ω-m for Finemet ribbons. Capacity of the samples was evaluated by electronic parameter analyzer device in two different frequencies of 100 kHz and 1000 kHz. Impedance measurements of coated samples in 100 and 1000 kHz showed an increase about 70 and 10 times respectively.

Keywords


  1. Gheiratmand T, Hosseini HRM. Finemet nanocrystalline soft magnetic alloy: Investigation of glass forming ability, crystallization mechanism, production techniques, magnetic softness and the effect of replacing the main constituents by other elements. Journal of Magnetism and Magnetic Materials. 2016;408:177-92.
  2. Shivaee HA, Golikand AN, Hosseini HRM, Asgari M. Influence of annealing on the electrochemical behavior of finemet amorphous and nanocrystalline alloy. Journal of Materials Science. 2009;45(2):546-51.
  3. Denis N, Inoue M, Fujisaki K, Itabashi H, Yano T. Iron Loss Reduction in Permanent Magnet Synchronous Motor by Using Stator Core Made of Nanocrystalline Magnetic Material. IEEE Transactions on Magnetics. 2017;53(11):1-6.
  4. Beatrice C, Dobák S, Ferrara E, Fiorillo F, Ragusa C, Füzer J, et al. Broadband magnetic losses of nanocrystalline ribbons and powder cores. Journal of Magnetism and Magnetic Materials. 2016;420:317-23.
  5. Varga LK. High-Frequency Inductor Materials. Journal of Electronic Materials. 2013;43(1):117-20.
  6. Osinalde M, Infante P, Domínguez L, Blanco JM, del Val JJ, Chizhik A, et al. Structural, magnetic characterization (dependencies of coercivity and loss with the frequency) of magnetic cores based in Finemet. Journal of Magnetism and Magnetic Materials. 2017;443:124-30.
  7. Jia Y, Wang Z, Wang F, Zhang L, Duan H. Effect of Ti on structure and soft magnetic properties of Si-rich Finemet-type nanocrystalline Fe 73.5 Cu 1 Nb 3- x Si 17.5 B 5 Ti x alloys. Materials Research Bulletin. 2018;106:296-300.
  8. Shivaee HA, Castellero A, Rizzi P, Tiberto P, Hosseini HRM, Baricco M. Effects of chemical composition on nanocrystallization kinetics, microstructure and magnetic properties of finemet-type amorphous alloys. Metals and Materials International. 2013;19(4):643-9.
  9. Peng X, Peng K, Zhang W. Synthesis of low core loss Finemet/Ni 0.5 Zn 0.5 Fe 2 O 4 composites by co-precipitation method. Materials Research Bulletin. 2018;100:138-44.
  10. Peng X, Peng K, Huang J. Synthesis and magnetic properties of core-shell structured Finemet/Ni Zn ferrite soft nanocomposites by co-precipitation. Journal of Alloys and Compounds. 2017;691:165-70.
  11. Wang Z, Liu J, Wang RW, Min JK, Lu ZH, Gan ZH, et al. Influence of Fabrication Process on Magnetic Properties of Co-Finemet Nanocrystalline Powder Core. Advanced Materials Research. 2011;399-401:1008-11.
  12. Li Z, Yao K, Li D, Ni X, Lu Z. Core loss analysis of Finemet type nanocrystalline alloy ribbon with different thickness. Progress in Natural Science: Materials International. 2017;27(5):588-92.
  13. Shokrollahi H, Janghorban K. Soft magnetic composite materials (SMCs). Journal of Materials Processing Technology. 2007;189(1-3):1-12.
  14. Lassalle VL, Zysler RD, Ferreira ML. Novel and facile synthesis of magnetic composites by a modified co-precipitation method. Materials Chemistry and Physics. 2011;130(1-2):624-34.
  15. Peng Y, Yi Y, Li L, Yi J, Nie J, Bao C. Iron-based soft magnetic composites with Al 2 O 3 insulation coating produced using sol–gel method. Materials & Design. 2016;109:390-5.
  16. Kim TH, Jee KK, Kim YB, Byun DJ, Han JH. High-frequency magnetic properties of soft magnetic cores based on nanocrystalline alloy powder prepared by thermal oxidation. Journal of Magnetism and Magnetic Materials. 2010;322(16):2423-7.
  17. Chiriac H, Lupu N, Stoian G, Corodeanu S, Ovari TA. Magnetic and structural peculiarities of rapidly solidified glass-coated FINEMET nanowires.  2017 IEEE International Magnetics Conference (INTERMAG); 2017/04: IEEE; 2017.
  18. Zhao YW, Zhang XK, Xiao JQ. Submicrometer Laminated Fe/SiO2 Soft Magnetic Composites?An Effective Route to Materials for High-Frequency Applications. Advanced Materials. 2005;17(7):915-8.
  19. Lu X, Liang G, Zhang Y. Structure and magnetic properties of FeCo–SiO2 nanocomposite synthesized by a novel wet chemical method. Materials Letters. 2007;61(27):4928-31.
  20. Wu S, Sun A, Zhai F, Wang J, Zhang Q, Xu W, et al. Annealing effects on magnetic properties of silicone-coated iron-based soft magnetic composites. Journal of Magnetism and Magnetic Materials. 2012;324(5):818-22.