Fabrication of Al/Graphite/Al2O3 Surface Hybrid Nano Composite by Friction Stir Processing and Investigating The Wear and Microstructural Properties of The Composite

Authors

Department of mechanical engineering, University of Tabriz

Abstract

Friction stir processing was applied for fabricating an aluminum alloy based hybrid nano composite
reinforced with nano sized Al2O3 and micro sized graphite particles. A mixture of Al2O3 and graphite
particles was packed into a groove with 1 mm width and 4.5 mm depth, which had been cut in 5083
aluminum plate of 10 mm thick. Packed groove was subjected to friction stir processing in order to
implement powder mixture into the aluminum alloy matrix. Microstructural properties were investigated by
means of optical microscopy and scanning electron microscopy (SEM). It was found that reinforcement
particle mixture was distributed uniformly in nugget zone. Wear resistance of composite was measured by
dry sliding wear test. As a result, hybrid composite revealed significant reduction in wear rate in comparison
with Al/AL2O3 composite produced by friction stir processing. Worn surface of the wear test samples were
examined by SEM in order to determine wear mechanism.

Keywords